2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 142Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 142

7Install the clutch shoe assembly on the crankshaft; then install the flange nut (left-hand thread)Tighten to 94 ft-lbNOTE:
the clutch cover 8Install the one-way clutch making sure that the green dot or the word OUTSIDE is directed away from the
crankcase 12Tighten the clutch cover cap screws to ft-lbMD1286 9Install gear shift position switch contact pins and springs
into the end of the shift shaft 13Install the air intake plateApply red Loctite #271 to the threads of the three Phillips-head
cap screws; then install and tighten securelyMD1043 10Install gear shift position switch making sure the O-ring is well-oiled