2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 147Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 147

3Mount the indicator tip of the dial indicator on the secondary driven bevel gear4While rocking the driven bevel gear back
Shim Thickness Checking Tooth Contact NOTE: After correcting backlash of the secondary driven bevel gear, it is necessary
to check tooth contact 1Remove the secondary driven output shaft assembly from the left-side crankcase half2Clean the secondary
driven bevel gear teeth of old oil and grease residue3Apply thin, even coat of machinist-layout dye to several teeth of the
gear4Install the secondary driven output shaft assembly5Rotate the secondary driven bevel gear several revolutions in both
directions6Examine the tooth contact pattern in the dye and compare the pattern to the illustrationsCorrecting Tooth Contact
ATV-0104 NOTE: If tooth contact pattern is comparable to the correct pattern illustration, no correction is necessary If
tooth contact pattern is comparable to an incorrect pattern, correct tooth contact according to the following chartTooth