2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 149Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 149

Measuring Crankshaft (Web-to-Web) 1Using calipers, measure the distance from the outside edge of one web to the outside edge
or fatigueAssembling 1Place driven gear #2 into driven gear #1; then align the alignment marks of driven gear #1 and driven
gear #22Using pair of needle-nose pliers, insert each spring part way into the slot; then install pin and push the springpin
assembly into the slot3Place the key and the large washer into position on the balancer shaft4Place the driven gear #1 assembly
onto the balancer shaft; then place the large and small washers onto the shaftNOTE: The crank balancerdriven gear assembly
is now completely assembled for installation ATV-1017 2Acceptable width range must be within specificationsCOUNTERSHAFT !
CAUTION When disassembling the countershaft, care must be taken to note the direction each major component (dog, gear) facesIf
major component is installed facing the wrong direction, transmission damage may occur andor the transmission will malfunctionIn