2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 152Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 152

Joining Crankcase Halves 1Verify that the two alignment pins are in place and that both case halves are clean and grease
together until cap screws can be installed3From the right side, install the crankcase cap screws noting the location of the
different-sized cap screws; then tighten only until snugNOTE: Rotate the shafts back and forth to ensure no binding or sticking
occurs while tightening the cap screws NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 6In
crisscrosscase-to-case pattern, tighten the mm cap screws to ft-lbNOTE: Rotate the shafts back and forth to ensure no binding