2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 178Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 178

Left-Side Components NOTE: For efficiency, it is preferable to remove and disassemble only those components which need to
The H1 models are not equipped with recoil starterCD920A 1Remove the four cap screws securing the recoil starterouter magneto
cover to the left-side cover; then remove the recoil starterouter magneto coverAccount for the gasket 5Loosen the clamps
securing the coolant hose to the water pump; then remove the crossover tube from the cylinder headAccount for an O-ring AT
THIS POINT To service the recoil starter, see Servicing Left-Side Components sub-section 2Remove the flange nut securing
the starter cupspacer to the crankshaft; then remove the starter cupspacerAccount for the O-ring inside the cup 6Remove the
two cap screws securing the water pump to the engine; then remove the water pump AT THIS POINT To service the water pump,
see Section 4 7Remove the cap screws securing the left-side cover to the crankcase noting the location of the different-sized