2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 179Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 179

8Using Side Case Puller, remove the side coverAccount for gasket and two alignment pinsNOTE: Inspect the inside of the left-side
the magneto rotor puller adapterNOTE: The puller has left-hand threads 10Using Magneto Rotor Remover Set, remove the rotorflywheel
assembly from the crankshaftAccount for the key; then remove the starter clutch gear assembly and washer 12Remove the snap
ring securing the water pump drive gear; then remove the gear noting the direction of the sides of the gear for installing
purposesAccount for the drive gear alignment pin 13Remove the snap ring securing the water pump driven gear; then remove