2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 182Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 182

Assembling 1If removed, insert the spiral spring into the case with the outer end of the spring around the mounting lug in
the handle and secure it with double knotInstall the protective cover into the handle5Align the inner hook of the spiral
spring with the notch in the reel NOTE: Increasing the rotations in step 10 will increase spring tension BSTARTER MOTOR AT
THIS POINT To service the starter motor, see Section 5 CWATER PUMP AT THIS POINT To service the water pump, see Section 4
Installing Left-Side Components NOTE: Plug the oil passage in the crankcase housing prior to installing the drive geardriven
gear assembly to prevent loss of an alignment pin 1Install the water pump driven gear alignment pin and the driven gear (with
the beveled side of the gear facing outward as noted in removing); then secure with the snap ring 6Install the ratchet making
sure the end is properly installed on the reel7Install the friction spring and the spring cover; then install the friction