2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 185Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 185

11Tighten the cap screws (from step 9) to ft-lb12Place the speed sensor housing and gasket into position and secure with
O-ring is properly positioned15Install the shift arm on the shift arm shaft making sure the scribed marks (from removing)
are alignedTighten securely16Place the gasket and recoil starterouter magneto cover into position on the left-side cover;
then tighten four cap screws to ft-lb 9Install the magneto cover and secure with the cap screwsTighten only until snug10Place