2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 189Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 189

14Remove the snap ring securing the oil pump driven gear (A); then remove the gear noting the direction of the sides of the
replace the clutch shoes as complete set or severe imbalance could occur 15Using an impact driver, remove the three Phillips-head
screws securing the oil pump; then remove the pump ATV1014 INSPECTING CLUTCH HOUSING 1Inspect the clutch housing for burns,
grooving, cracks, or uneven wear2If the housing is damaged in any way, the housing must be replacedCD988 INSPECTING PRIMARY
ONE-WAY DRIVE 1Insert the drive into the clutch housing2Rotate the inner race by hand and verify the inner race rotates only