2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 190Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 190

2It is inadvisable to remove the screw securing the pump halvesIf the oil pump is damaged, it must be replaced CD048 3Install
4Using suitable marking pen, make alignment marks on the fixed face spring holder and both pulley faces 1Secure Driven Pulley
Compressor in suitable holding fixture such as bench vise; then remove the wing nut, holding handle, flat washer, and pilot
bushing leaving the large spacer on the compressor tool base 5Place the holding handle on the spring holder fitting the two
dowel pins into the spring holder face; then install flat washer and the wing nutTurn the wing nut down until resistance