2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 195Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 195

NOTE: When installed correctly, the sides of the drive and driven gears will be flush with each other 8Install the clutch
the flange nut (threads coated with red Loctite #271)Tighten to 94 ft-lb (500) or 221 ft-lb (H1 Models) 7Lightly grease the
clutch housing seal; then insert the left fixed drive spacer ! CAUTION When installed correctly, the green alignment dot
(or the word OUTSIDE) on the one-way clutch is visible 11Place the clutch coverclutch housing assembly into position on the
crankcase; then secure with the cap screws making sure the different-lengthed cap screws are in their proper locationTighten