2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 196Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 196

12Place the air intake plate cushion into position; then install the air intake plateTighten the cap screws (threads treated
the nutTighten to 94 ft-lb (500) or 221 ft-lb (H1 Models) NOTE: At this point, the push-bolt can be removed from between
the driven pulley faces 18Rotate the V-belt and drivedriven assemblies until the V-belt is flush with the top of the driven
pulleyCF262 14Slide the fixed drive face onto the shaft15Spread the faces of the driven pulley by pushing the inner face
toward the engine while turning it counterclockwise (500) or thread in push-bolt (H1 Models); then when the faces are separated,
insert the belt and push down between the faces16Place the V-belt into position on the driven pulley and over the front shaft