2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 200Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 200

2If backlash measurement is more than specified, remove an existing shim, measure it, and install thicker shimNOTE: Continue
of machinist-layout dye to several teeth of the gear4Install the secondary driven output shaft assembly5Rotate the secondary
driven bevel gear several revolutions in both directions6Examine the tooth contact pattern in the dye and compare the pattern
to the illustrations If tooth contact pattern is comparable to an incorrect pattern, correct tooth contact according to the
following chartTooth Contact Contacts at Top Contacts at Root Shim Correction Decrease Shim Thickness Increase Shim Thickness
NOTE: To correct tooth contact, steps and (with NOTE) of "Correcting Backlash" must be followed and the above "Tooth ContactShim
Correction" chart must be consulted ! CAUTION After correcting tooth contact, backlash must again be checked and corrected
(if necessary)Continue the correcting backlashcorrecting tooth contact procedures until they are both within tolerance values