2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 201Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 201

2Acceptable width range must be within specificationsMeasuring Crankshaft (Runout) 1Place the crankshaft on set of blocks2Mount
rod to one side of the crankshaft journal2Using feeler gauge, measure the gap between the connecting rod and crankshaft journal
ATV-1074 3Zero the indicator and rotate the crankshaft slowly ! CAUTION Care should be taken to support the connecting rod
when rotating the crankshaft 4Maximum runout must not exceed specificationsNOTE: Proceed to check runout on the other end
of the crankshaft by positioning the indicator contact at point and following steps 3-4 Measuring Crankshaft (Web-to-Web)
1Using calipers, measure the distance from the outside edge of one web to the outside edge of the other web 3Acceptable gap
range must be within specificationsMeasuring Connecting Rod (Big End Width) 1Using calipers, measure the width of the connecting