2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 203Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 203

6Install the driveshaft NOTE: If heating the bearing is not possible, the crankshaft can be installed using crankshaft installing
each end of the gear shift shaft; then install the shaft assembly making sure the two holes on the end of the shaft are positioned
vertically9Insert the two shift forks into the sliding dogs noting the direction of the tabs from disassembling; then install
the shift fork shaftNOTE: Make sure the shift fork tabs face upward and that they are properly seated into the shift cams