2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 204Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 204

Joining Crankcase Halves 1Apply High-Temp Sealant to the left-side mating surface2Lightly oil all bearings and grease all
6From the left side, install the remaining mm cap screws (two inside the case); then tighten only until snugNOTE: Rotate
the shafts back and forth to ensure no binding or sticking occurs 7From the left side, install the case half mm cap screws;
then tighten only until snugNOTE: Rotate the shafts back and forth to ensure no binding or sticking occursCD268A 12Place
the oil strainer into position; then secure with the two screws13Place the oil strainer cap into position making sure the
O-ring is in position (500) or silicon sealant is applied (H1 Models); then secure the cap with cap screwsTighten securely
8From the right side, install the mm cap screws; then tighten only until snugNOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs 9In crisscrosscase-to-case pattern, tighten the mm cap screws (from steps 5-6) until the halves