2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 205Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 205

10In crisscrosscase-to-case pattern, tighten the mm cap screws (from steps 7-8) to ft-lbNOTE: Rotate the shafts back and
through-bolts, two bushings, and two washers; then tighten the through-bolt flange nuts to 40 ft-lb 1From the left side,
place the enginetransmission into the frame; then slide the engine rearward as far as possible2Slightly raise the rear of
the engine and engage the front drive coupler into the splines of the front drive output yoke; then slide the engine forward
as far as possible 6Secure the exhaust pipe to the engine with two cap screws making sure the mounting brackets engage the
frame grommets; then install the muffler and tighten the nuts securing the exhaust pipe to 20 ft-lb 3Raise the rear of the