2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 225Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 225

CCylinder HeadCamshaft DValve CoverRocker Arms NOTE: Steps 1-5 in the preceding sub-section must precede this procedure 6Place
pattern, tighten the four mm nuts (from step 9) to ft-lbTighten the two cylinder-to- crankcase nuts (from step 4) securely11With
the timing inspection plug removed and the chain held tight, rotate the crankshaft until the piston is at top-dead-centerNOTE:
At this point, oil the camshaft bearings, cam lobes, and the three seating journals on the cylinder 8Install the four cylinder
head cap screws with copper washers (note the locations of the different-lengthed cap screws)Tighten only until snug3-192
12With the alignment pin installed in the camshaft, loosely place the cam sprocket (with the recessed side facing the cam