2009 Polaris Outlaw 450/525 Service Manual, Page 208Get this manual

2009 Polaris Outlaw 450/525 Service Manual, Page 208

5-7 Measuring the outer dimension of the crankshaft webs Measure the outer dimension of the crankshaft webs with sliding
screwsHeat the drive wheel to approx100C to mount Degrease the screws on the drive wheel and apply Loctite 243 Position the
drive wheel on the crankshaft, aligning the mark with the crankpin Mount the screws and tighten to 10 Nm To mount the new
inner ring, reheat the special tool to approx150C, clamp the inner ring and immediately slide it onto the crankshaft journal
Allow the inner ring to cool for approx30 seconds and tap the inner ring with suitable pipe to make sure it is fully seated
Measure the axial clearance of the crankshaft after the inner rings are replaced Measuring the axial clearance of the crankshaft
and the transmission shafts Insert the crankshaft and all transmission shafts in the right case halfMount the left case half
Mount and tighten the case screws Mount the dial gauge support on the engine caseMeasure the axial clearance of the crankshaft