2009 Polaris Outlaw 450/525 Service Manual, Page 216Get this manual

2009 Polaris Outlaw 450/525 Service Manual, Page 216

Press the shaft seal rings out of the gasket carrier Press in the new shaft seal rings with the open side on the outside
the cylinder head top section NOTE: To prevent coolant leaks, it's recommended to remove the top section of the cylinder
head along with the gasket carrierSealant can then be added to both components upon reassembly to prevent leakage from the
mating surface areas Premounting the camshaft Apply Loctite 243 to the thread of the screws and mount the camshaft gear 7Tighten
the screws to 28 Nm Press on both grooved ball bearings Mount the automatic decompression shaft and the spring 9Pretension