2009 Polaris Outlaw 450/525 Service Manual, Page 233Get this manual

2009 Polaris Outlaw 450/525 Service Manual, Page 233

6-8 Mounting the outer clutch hub and the clutch driver Mount the supporting plate and the oiled needle bearings Slip the
outer clutch hub with special tool PA-48685 (see photo) and tighten the nut to 120 Nm Lock the nut with the lock washerNOTE:
used driver can usually be mounted without heating Screwing the nut on the primary gear Pull out the starter idler shaft,
leaving the torque limiter in the engine case Position special tool PA-48685 as illustrated Degrease the thread on the crankshaft