2009 Polaris Outlaw 450/525 Service Manual, Page 237Get this manual

2009 Polaris Outlaw 450/525 Service Manual, Page 237

6-12 M6x55 (10.9) Mounting the cylinder head top section Insert the dowels in the cylinder head Degrease the sealing area
endpiece Tighten the remaining screws in crosswise direction to 10 NmRocker arm axial clearance 0.020.10 mm Only perform
the following steps if you removed the gasket carrier from the camshaftCAUTIONIT IS IMPORTANT TO USE MOUNTING SLEEVE OTHERWISE
THE SHAFT SEAL RINGS WILL BE DAMAGED Slip on the seal installer PA-48678 Grease the O-rings and shaft seal rings Mount the
gasket carrier with the drain bore facing up and the collar facing the camshaft gear without cocking it sideways Remove the