2009 Polaris Outlaw 450/525 Service Manual, Page 251Get this manual

2009 Polaris Outlaw 450/525 Service Manual, Page 251

8-9 Checkingadjusting the float height Tilt the carburetor until the float rests against the float needle valve without compressing
basic setting of the throttle sensor Use the adjusting screw to set the opening of the throttle slide to mmThis test is easily
performed with mm drill bit shaft or wireNOTE: check andor adjust the idling position Checkingadjusting the operation of
the accelerator pump NOTE: adjusting the accelerator pump clearance will change the beginning of injection and will not affect
the quantity injected or intensity of the accelerator pump0.9 mm 1mm opening of the throttle slide is prerequisite for the
correct adjustment of the accelerator pump operation The basic setting for the accelerator pump piston rod projection is