2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 24Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 24

MAINTENANCE 5Hold rod end parallel to mounting surface and tighten jam nuts securely PILOT SCREW The pilot system supplies
quality standards are not exceeded Center Lever In Slot THROTTLE OPERATION Check for smooth throttle opening and closing
in all handlebar positionsThrottle lever operation should be smooth and lever must return freely without bindingPlace the
gear selector in neutralSet parking brakeStart the engine and let it idleTurn handlebars from full right to full leftIf idle
speed increases at any point in the turning range, inspect throttle cable routing and conditionIf cable is routed properly
and in good condition, repeat adjustment procedure5Replace the throttle cable if worn, kinked, or damaged1234Pilot Screw