2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 38Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 38

MAINTENANCE NOTE: The sealing surfaces on the drain plug and crankcase should be clean and free of burrs, nicks or scratchesReference
contacts sealing surface, then turn an additional 12 turn Oil Filter Wrench: (PV-43527) Oil Tank Screen Fitting Torque: See
Step 12 Recommended Engine Oil: Polaris Premium All Season Synthetic, 0W-40, (PN 2871281) Ambient Temperature Range: -40
to 120 F 15Using clean dry cloth, clean filter sealing surface on crankcase16Lubricate O-ring on new filter with film of
engine oilCheck to make sure the O-ring is in good condition17Install new filter and turn by hand until filter gasket contacts
the sealing surface, then turn and additional 12 turn Crankcase Drain OIL PUMP PRIMING PROCEDURE NOTE: This priming procedure
must be performed whenever the oil hose connection between the oil tank and pump inlet has been disconnected or if the sump
has been allowed to drain1Clamp or pinch off vent line (A) approximately from oil tank, between the end of oil tank vent