2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 40Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 40

MAINTENANCE adjustment of each valveINTAKE VALVE CLEARANCE .006 (.15 mm) 3Hold adjuster screw and tighten adjuster lock nut
placeIf cotter pins are removed, they must not be re-usedAlways use new cotter pinsReplace any worn or damaged steering componentsSteering
should move freely through entire range of travel without bindingCheck routing of all cables, hoses, and wiring to be sure
the steering mechanism is not restricted or limitedNOTE: Whenever steering components are replaced, check front end alignmentUse
only genuine Polaris partsWARNING Due to the critical nature of the procedures outlined in this chapter, Polaris recommends
steering component repair and adjustment be performed by an authorized Polaris DealerOnly qualified technician should replace
worn or damaged steering partsUse only genuine Polaris replacement partsFeeler Gauge for Both Valves 2Loosen locknut(s) and
turn adjuster screw(s) until there is slight drag on feeler gauge(s)The ValveClutch Adjuster Tool (PA-44689) can be used