2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 49Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 49

MAINTENANCE CV SHAFT BOOT INSPECTION Inspect the cv shaft boots in the front of the ATV for damage, tears, wear, or leaking
nuts slightly3Elevate the side of the vehicle by placing suitable stand under the footrest frame4Remove the wheel nuts and
remove the wheelFront Wheel Front Spindle Nut See Ch7 Inspect Boots CONTROLS Check controls for proper operation, positioning
and adjustment Front Wheel Nuts (4) 27 ftlbs(34 Nm) Rear Wheel Rear Wheel Nuts (4) 50 ftlbs(68 Nm) Brake control and switch
must be positioned to allow brake lever to travel throughout entire range without contacting switch body Taper end faces
wheel for install Inspect all wheels for runout or damageCheck wheel nuts and ensure they are tightDo not over tighten the