2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 58Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 58

ACCESSIBLE COMPONENTS The following components can be serviced or removed with the engine installed in the frame: Flywheel
from gear selector and secure out of the way16Disconnect coolant temperature sensor wire17Remove engine to chassis ground
cable18Remove all engine mount nuts andor engine mount plates19Remove engine through right side of frame ENGINE INSTALLATION
NOTES After the engine is installed in the frame, review this checklist and perform all steps that apply General Items 1Install
previously removed components using new gaskets, seals, and fasteners where applicable2Perform regular checks on fluid levels,
controls, and all important areas on the vehicle as outlined in the daily pre-ride inspection checklist (refer to Chapter
or the Owner's Safety and Maintenance Manual)PVT System 1Adjust center distance of drive and driven clutch(Chapter 6) 2Adjust
clutch offset, alignment, and belt deflection(Chapter 6) 3Clean clutch sheaves thoroughly and inspect inlet and outlet ducts