2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 90Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 90

COUNTER BALANCER SHAFT END PLAY ADJUSTStep 2 Counter Balancer Shaft End Play: .008 -.016 (.02-.04 cm) OIL PUMP SHAFT END
mating surface to the balance shaft bearing using dial caliper and straight edgeSubtract the thickness of the straightedge
and record4Measure the distance from the PTO crankcase mating surface to the bearing using the same method outlined in Step
1, 2, and-35Add the readings obtained in Step and Step 46Subtract the counter balancer shaft width measured in Step from
the figure obtained in Step 57Subtract the thickness of the existing shim from the result of Step to determine if different
shim is neededThe result must be within the specified range listed at below 3Install the gear on the oil pump and measure