2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 92Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 92

ENGINE 4Install the crankcase flange bolts and tighten in steps following the pattern on Page 3.2 to specified torqueCrankcase
Pump Mechanical Seal Puller: (PN 2872105) Replacement T-Handle: (PN 2872106) This tool allows technician to replace the mechanical
water pump seal on EH50PL engines without removing the engine and splitting the cases Ill2 2Slide the main puller body over
the outer portion of the mechanical seal as shown in Ill2 and turn T-Handle clockwise until it contacts water pump shaftContinue
rotating until outer portion of mechanical seal is separated from the metal seal body3Insert the puller legs between the
water pump drive shaft and the remaining portion of the mechanical sealAttach the puller legs to the main puller bodyIll3
Main puller body CAUTION: Improper or careless use of this tool or procedure can result in bent water pump shaftPump shaft
replacement requires engine removal and crankcase separationUse caution while performing this procedureMake sure that the