2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 94Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 94

TENSIONER BLADE INSTALLATION 1Install the tensioner blade and tighten the mounting bolt to specified torqueTensioner Blade
forwardThe expander has no up or down marking and can be installed either wayThe ends should butt squarely together and must
not overlap2Install the oil ring top railNOTE: The top rail has locating tab to prevent rotationThe tab must be positioned
in the notch on the side of the piston as shown (A) Second Mark up ILL1 PISTON INSTALLATION 1Clean the gasket surfaces on
the cylinder and crankcaseRemove all traces of old gasket material2Make sure the cylinder mounting bolt holes are clean and
free of debris Tang Outward A 3Install the bottom rail with the gap at least 30 from the end of the expander on the side
opposite the top rail gapSee ILL1)4Install the second ring with the "R" mark facing upPosition the end gap toward the rear