2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 95Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 95

ENGINE compress the new clip more than necessary upon installation to prevent loss of radial tensionSevere engine damage
or down and tang outward(See Caution with Step above)Push the piston pin in both directions to make sure the clips are properly
seated in the groove 4Apply clean engine oil liberally to the cylinder bore and tapered area of the sleeveInstall the cylinder
with slight rocking motion until the rings are captive in the sleeve CYLINDER INSTALLATION 1Place the dowel pins in the crankcase
and install new cylinder base gasket A 5Remove the ring compressor and support block6Push the cylinder downward until fully
seated on the base gasket7Apply light film of oil to the threads and flange surface of the cylinder mounting bolts8Install
all four bolts finger tightRotate the engine and position the piston at BDCNOTE: If cam chain is installed, hold it up while