2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 102Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 102

ENGINE To reinstall an old spring: 1Hook outer tab in place in recoil housing and wind spring in counterclockwise direction
remove spring one coil at time from the inside out19Pull knot out of of recoil reelUntie knotRemove rope from reel RECOIL
ASSEMBLY CAUTION: Be sure to wear face shield and eye protection when performing this procedureNOTEInformation only2009 models
not equipped NOTEInformation only2009 models not equipped To install new spring: 1Place spring in housing with the end positioned
so the spring spirals inward in counterclockwise directionSee photo at right2Hold spring in place and cut retaining wire
5Install reel into housing making sure the spring drive tab on the reel engages the spring and the reel is fully seated in
the housing6Apply downward pressure on the reel and rotate counterclockwise approximately 6-7 turns to pre-wind the springContinue
rotating counterclockwise until rope on outer edge aligns with rope guide bushing7Release rope from notch and allow reel