2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 125Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 125

BODYSTEERINGSUSPENSION A-ARM REPLACEMENT Vehicle Frame Bolt 30 ftlbs(41 Nm) Apply Loctite 242 to the bolt threads Bolt 30
not aligned, tighten nut slightly to alignInstall new cotter pin with open ends toward rear of machineBend both ends in opposite
directions around nut9Locate grease fitting in center of A-arm tube and pump A-arm full of greaseWARNING Upon A-arm installation
completion, test vehicle at low speeds before putting into regular serviceA-arm Attaching Bolt Torque: 30 ftlbs(41 Nm) Ball
Joint Stud Nut Torque: 25 ftlbs(35 Nm) The locking features on the existing bolts were destroyed during removalDO NOT reuse
old boltsSerious injury or death could result if fasteners come loose during operation5Examine A-arm shaftReplace if wornDiscard