2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 127Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 127

BODYSTEERINGSUSPENSION CONCENTRIC SWING ARM ASSEMBLYINSTALLATION 150 ftlbs(207 Nm) (1) Nut 120 ftlbs(163 Nm) (8) Pivot Bolt
bushing (6) in left side of swingarm and two-piece bushings (3) in right side2Clean threads of nut (1) and pivot bushings
(4) 3Install right pivot bushing (4) through the two-piece bushing (3)4Install washer (2) and nut (1)Hold pivot bushing (4)
in vise and torque nut (1) to 120 ftlbs(163 Nm)5Install left pivot bushing (7)6Install swingarm assembly in frame 7Install
and tighten pivot bolts slowly until the flats of the pivot bushings (4) and (7) engage the stop plate on the frame8Torque
pivot bolts (5) and (8) to 150 ftlbs(207 Nm)9Install the pivot bolt retainers and install boltsTorque to 1517ftlbs(1923 Nm)NOTE:
If retainers cannot be aligned for bolt installation, tighten pivot bolt until alignment is achieved9Install lower rear shock