2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 138Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 138

CLUTCHING PVT ASSEMBLY Seal this edge to cover on engine side Inner Cover Bolt Torque (Rear): 12 ftlbs(16.6 Nm) Driven Clutch
and tighten screws securely6Torque rear inner cover bolts (B) to specification 7Install clutch offset spacers on transmission
input shaft8Clean splines inside driven clutch and on the transmission input shaft9Apply light film of grease to the splines
on the shaft10Install the driven clutch, washer, lock washer, and retaining boltTorque to specification11Clean end of taper
on crankshaft and the taper bore inside drive clutch12Install drive clutch and torque retaining bolt to specification13Reinstall
drive belt noting direction of rotationIf new belt is installed, install so numbers can be easily readToward outer cover