2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 146Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 146

CLUTCHING NOTE: Pinch the sheaves lightly together with clamp to prevent the belt from being pushed into the driven sheave1Place
and rearward on belt to open driven clutch sheaves, pull out and down on belt to slip over the driven clutch outer sheaveProjected
Belt Width DRIVE BELT REMOVALINSPECTION 1Remove outer PVT cover as described in PVT Disassembly2Mark drive belt direction
of rotation so that it can be installed in the same directionNOTE: Normally positioned so part numbers are easily readBelt
Width: New 1.1741.188 (2.98-3.02 cm) Wear Limit 1.125 (2.86 cm) 4Measure belt width and replace if worn severelyGenerally,
belt should be replaced if clutches can no longer be adjusted to provide proper belt deflectionG The top edges have been
trimmed on some drive beltsIt will be necessary to project the side profiles and measure from corner to cornerG Place straight