2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 147Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 147

CLUTCHING 5Inspect belt for loose cords, missing cogs, cracks, abrasions, thin spots, or excessive wearReplace if necessary6Inspect
require driven shimming or shorter center distanceRemember, proper belt deflection is the desired goalnot specific center
distance8Replace belt if worn past the service limitBelts with thin spots, burn marks, etc should be replaced to eliminate
noise, vibration, or erratic PVT operationSee Troubleshooting Chart at the end of this chapter for possible causesNOTE: If
new belt is installed, check belt deflection 1Loop belt over drive and over top of driven sheave2While pushing down on top
of belt, turn the back or moveable driven sheave clockwise3The belt then should be able to be pushed down into and between