2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 148Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 148

CLUTCHING 1Remove belt and install the Clutch Offset Alignment Tool (PN 2870654) as shown2With tool touching rear of driven
if necessaryNOTE: On some models, minor adjustments can be made by adding shims between the frame and front lower left engine
mount to increase the distance at point "A"If shim is present, it can be removed to decrease the distance at point "A"Shim
Kit (PN 2200126) Important: Inspect clutch alignment and center distance before adjusting offset1Install offset alignment
tool as shownOffset is correct when rear of tool contacts rear of inner sheave with driven clutch pushed completely inward
on shaft and bolt torquedAdjust offset by adding or removing spacer washers between back of driven clutch and spacer as shownSpacer