2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 154Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 154

CLUTCHING DRIVEN CLUTCH MOVEABLE SHEAVEBUSHING REMOVAL NOTE: Bushings are installed at the factory using Loctite In order
of clutch sheave with smaller diameter toward bushing to be removedSee illustration at above Piston Pin Puller (PN 2870386)
Adapter Reducer (#9) 1Install Main Puller Adapter (#8) (PN 5020632) onto the Piston Pin Puller (PN 2870386)2Insert Adapter
Reducer (#9) (PN 5010279) onto the puller, sliding it inside the main adapter3Remove ramp buttons from moveable sheave 4Using
an electric or hand held propane torch, apply heat directly on bushing until tiny smoke tailings appearCAUTION: Clutch components