2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 166Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 166

FINAL DRIVE 6Without removing the garter spring, inspect the coils for consistencyIf coils are distorted or uneven, cut the
If this procedure is not followed the spring will be over stressed and lose its tensionSprings with incorrect tension may
allow rollers to move outward at high vehicle speedsIf the rollers move outward, the front hub(s) will engage and cause vehicle
instability, which could result in serious injury or deathMust use Hilliard Clutch Garter Spring Installation Tool (PN 2870888)
AWD ARMATURE PLATE INSPECTION Seal Sleeve Armature Plate Tabs WARNING: Be sure to use correct garter springThese springs
are very similar in appearance to those used on earlier modelsIf the old, lighter springs were installed on machine requiring
the heavier spring, the front wheels may engage at high speed, possibly resulting in serious injury or deathCheck springs
before installationAlways verify the correct 1As the armature plate is engaged, it should contact the outer magnet pole (seal