2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 169Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 169

FINAL DRIVE 2Remove cotter pin and castle nut from A-arm ball joint3Disconnect A-arm from ball joint using tie rod fork5Remove
joint grease may be contaminatedInspect the grease carefully for contamination, and clean the joint thoroughly if necessaryFront
drive axle CV boot replacement requires 30g of greaseIf CV joint is cleaned, an additional 30g of grease is requiredRefer
to information below8Before installing the new boot, remove all grease from the boot area and shaftNOTE: It is very important
to use the correct type and quantity of grease by using the grease contained in 4Slide strut off end of drive shaft and tie