2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 172Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 172

FINAL DRIVE AWD STRUT CASTING FRONT DRIVE AXLE SEAL REPLACEMENT BEARING REPLACEMENT NOTE FOR FRONT DRIVE AXLE AND FRONT HUB
the shoulder in the strut casting Seal Sleeve Pull strut off drive shaft 1If front axle sleeves become damaged and leak fluid
they are replaceableUsing hammer and drift punch, remove the seal sleeve by driving it off evenly being careful not to nick
or damage the sleeve mounting area (A)2Coat the sleeve mounting area (A) with silicone and using extreme care, press the
new seal sleeve onto area (A) until it bottomsAllow 12 hours for silicone to cure 4Apply grease to the seal inner lip, reinstall
the spindle and axle assembly5Reinstall the A-arm to the ball jointTorque to 25 ftlbs(35 Nm)NOTE: If the cotter pin hole