2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 173Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 173

FINAL DRIVE Hub Seal Sleeve Replacement 3New front drive axle CV joint assemblies and drive axle assemblies have the seal
(PN 2871199)5To check the gap between the inner and outer poles place straight edge on the outer pole so that it just intersects
with the inner poleThe gap between the straight edge and inner pole should be to .001 (0-.025mm)This measurement should be
checked in three different positions around the pole assembliesThe three measurements must be within .0005 (.013 mm) of each
otherIf the gap is excessive, the hub may notengageSeal Sleeve Tool Use flat side to install seal sleeve AWD FRONT PROP SHAFT
REMOVAL 1Using Roller Pin Removal Tool (PN 2872608), remove the roll pin from the prop shaft at rear of housingSlide prop