2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 176Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 176

FINAL DRIVE 2Remove bolts and output shaft cover6Unscrew fill plug and remove pinion shaft assemblyInspect pinion gear for
2Press pinion shaft seal into pinion cover until flush with sealing surface3Inspect pinion and output shaft bushingsInspect
bearings on output and pinion shaftsTo replace, press new bearing onto shaft 5Remove pinion cover and O-ring NOTE: Due to
extremely close tolerances and minimal wear, the bearings must be inspected visually, and by feelWhile rotating bearings
by hand, inspect for rough spots, discoloration, or corrosionThe bearings should turn smoothly and quietly, with no detectable