2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 196Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 196

BRAKE SYSTEM MAIN COMPONENTS TOP VIEW MASTER CYLINDER RIGHT BRAKE CALIPER CROSS FITTING BRAKE SWITCH LEFT BRAKE CALIPER BANJO
cylinder reservoir fluid level after pad serviceMake sure atmospheric vent on reservoir is unobstructed Test for brake drag
after any brake system service and investigate cause if brake drag is evidentMake sure caliper moves freely on guide pins
(where applicable)Inspect caliper piston seals for foreign material that could prevent caliper pistons from returning freely
Use only DOT brake fluid as an assembly aid for all procedures described in this chapter to prevent brake system contaminationDO
NOT USE LUBRICANTS OF ANY KIND FOR ASSEMBLY CAUTION: BRAKE NOISE TROUBLESHOOTING Dirt or dust buildup on the brake pads and
disc is the most common cause of brake noise (squeal caused by vibration)If cleaning does not reduce the occurrence of brake
noise, Permatex Disc Brake Quiet (PN 2872113) can be applied to the back of the padsFollow directions on the packageThis