2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 198Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 198

BRAKES 3Inspect vent slots (A) in cover and remove any debris or blockageC Sight Glass A D Ill1 4If changing fluid, remove
(F)Close bleeder screw and release brake leverNOTE: Do not release lever before bleeder screw is tight or air may be drawn
into caliperBleeder Screw Torque 25-30 in.lbs(2.80 -3.40 Nm) Polaris DOT Brake Fluid (PN 2870990) 9Repeat procedure until
clean fluid appears in bleeder hose and all air has been purgedAdd fluid as necessary to maintain level in reservoirCAUTION:
Maintain at least 12 (1.27 cm) of brake fluid in the reservoir to prevent air from entering the master cylinder10Tighten
bleeder screw securely and remove bleeder hoseTorque the bleeder screw to 2530 in.lbs(2.80 3.40 Nm) Mity Vac (PN 2870975)
5Add brake fluid to the indicated MAX level inside reservoir Rear Brake Caliper Bleeding Procedure 6Begin bleeding procedure