2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 227Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 227

ELECTRICAL ELECTRONIC THROTTLE CONTROL (ETC) SWITCH The Electronic Throttle Control (ETC) system is designed to stop the
engine stop switch "OFF"Test the ETC switch at the harness connectorNOTE: Adjust throttle cable freeplay (ETC switch) and
make sure throttle mechanism is functioning properly before testing the switchRefer to Maintenance Chapter for cable adjustment
procedure ETC OPERATION TEST Remove throttle block cover by carefully releasing all tabs around edge of coverPlace transmission
in neutral and apply parking brakeStart engine and open throttle lever slightly until engine RPM is just above idle speedHold
throttle cable with fingers at point "A" as shown below and release throttle leverIf the ETC system is functioning properly,
the engine will lose spark and stopElectronic Throttle Control (ETC) Switch (Composite Throttle Housing) ETC switch contacts