2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 230Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 230

ELECTRICAL IGNITION SYSTEM TESTING FLOW CHART Whenever troubleshooting an electrical problem, first check all terminal connections
getting to the CDI moduleRefer to the wiring schematic for meter connections and specificationsCompare results to the specifications
on the exploded viewsAre all within specifications? Inspect battery, switches, connectors, and wiring to the component in
questionReplace the faulty component if wiring problem cannot be found Check coil ground connection between engine and coil
mount using an ohmmeterThe coil should have good continuity to ground on the engine (0-.2 Repair ground wire connections
Disconnect and check the secondary coilResistance values should be: Primary SidePrimary Wire Tab to Ground (on coil mount
or engine): .3 to .5 Ohms Secondary Side High Tension Wire to High Tension Wire Cap installed10,500 Cap removed6300 Are these