2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 243Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 243

ELECTRICAL 5Charge battery at 110 of its amphour ratingExamples: 110 of amp battery.9 amp; 110 of 14 amp battery1.4 amp;
inside the batteryBattery life may be reduced5Reinstall the battery caps CONVENTIONAL BATTERY INSPECTIONREMOVAL The battery
is located under the seat and right rear fender Battery Location Inspect the battery fluid levelWhen the battery fluid nears
the lower level, remove the battery and fill with distilled water only to the upper level lineTo remove the battery: CONVENTIONAL
BATTERY INSTALLATION 1Clean battery cables and terminals with stiff wire brushCorrosion can be removed using solution of
one cup water and one tablespoon baking sodaRinse well with clean water and dry thoroughly2Route the cables correctly3Reinstall
battery, attaching positive (+) (red) cable first and then the negative (-) (black) cableCoat terminals and bolt threads
with Nyogel Grease (PN 2871329)4Install clear battery vent tube from vehicle to battery ventWARNING: Vent tube must be free
from obstructions and kinks and securely installedIf not, battery gases could accumulate and cause an explosionThe vent tube